Mossberg 46 CENTERFIRE - Manual (Page 10)

REAR SIGHT ADJUSTMENT (MARBLE ARMS SIGHT)
Elevation may be adjusted by folding the rear sight blade forward and down.
Loosen the screw, which is located on the sight blade. This will allow the center
notch piece to be moved vertically for height adjustment.
(Note: To prevent the
sight screw from being lost, loosen only enough to move the center notch
piece for adjustment). The reversible center notch piece allows either a “U” or
“V” shaped notch to be used. Tighten the screw after adjustment.
Windage may be adjusted by turning the screw on the right side of the sight base
either clockwise or counterclockwise. Turning the screw clockwise moves the
sight to the right, counterclockwise moves the sight to the left.
Remember: Move the rear sight in the same direction you would want the shot
to move. For example, if the point of impact is low and to the left from the point
of aim, move the rear sight upward and to the right.
REAR SIGHT ADJUSTMENT (WILLIAMS SIGHT)
Elevation may be adjusted by turning the elevation adjusting screw clockwise to
raise the point of impact, or counterclockwise to lower the point of impact.
Windage may be adjusted by loosening the locking screw on the sight blade,
then moving the sight blade in the desired direction. Left will move the point of
impact to the left, right will move the point of impact to the right. Tighten the
locking screw after moving the sight blade.
Remember: Move the rear sight in the same direction you would want the shot
to move. For example, if the point of impact is low and to the left from the point
of aim, move the rear sight upward and to the right.
10
122005 8/1/11 1:36 PM Page 10