Mossberg 46 RIMFIRE User Manual
Page 9
9
9
L
LU
UB
BR
RIIC
CA
AT
TIIN
NG
G T
TH
HE
E A
AC
CT
TIIO
ON
N
Apply a few small drops of oil on the following surfaces (Fig. 5):
a.
Along the bolt surfaces.
b.
The bolt guide rails.
c.
Finger lever pivot
F
FU
UN
NC
CT
TIIO
ON
N T
TE
ES
ST
TIIN
NG
G
AFTER PERFORMING ANY WORK ON YOUR FIREARM SUCH AS
CLEANING, DISASSEMBLY OR INSTALLATION OF AN ACCESSORY:
a.
Move the safety button fully rearward to the “ON” (SAFE) position and
keep the muzzle pointed in a safe direction.
b.
O
Op
pe
en
n tth
he
e a
ac
cttiio
on
n a
an
nd
d v
viis
su
ua
alllly
y a
an
nd
d p
ph
hy
ys
siic
ca
alllly
y iin
ns
sp
pe
ec
ctt tth
he
e c
ch
ha
am
mb
be
err,,
a
an
nd
d ffe
ee
ed
d tth
hrro
oa
att tto
o b
be
e c
ce
errtta
aiin
n tth
he
e ffiirre
ea
arrm
m iis
s u
un
nllo
oa
ad
de
ed
d ((F
Fiig
g.. 3
3))..
Keep the safety button fully rearward in the “ON” (SAFE) position. Keep the
muzzle pointed in a safe direction. Open and close the lever several times to
check for free movement of the action assembly.
Close the lever and leave the safety button fully rearward in the “ON” (SAFE)
position. With the lever held loosely (not tight against the stock), try pulling the
trigger. The trigger should not move fully rearward and the hammer should not fall.
Keep the safety button fully rearward in the “ON” (SAFE) position. Squeeze the
lever tight against the stock and pull the trigger. The trigger should move fully
rearward. The hammer should only partially fall and not strike the firing pin. (As a
check, keep squeezing the lever tight against the stock and pulling the trigger
fully rearward. Try to push the hammer forward. You should not be able to push
the hammer forward and make contact with the firing pin).
BOLT TOP SURFACES
BOLT GUIDE RAIL
SURFACES
BOLT BOTTOM SURFACES
FINGER LEVER PIVOT
(Not Visible)
F
Fiig
g.. 5
5
66629 2/17/09 8:16 AM Page 9