NEMO Equipment ZO SHORT - Manual (Page 2)

Inflate
Adjust Firmness
With the valve closed, lay on the pad to test the comfort. Add or release air to adjust the
firmness of the pad.
Open Valve
To open the valve, twist counter clockwise and pull. Lay the Zor™ sleeping pad flat.
The longer you leave the pad with its valves open, the more it will partially self-inflate
Packing Away
To deflate, open the valve and roll out as much air as possible. Then close the valve,
unroll the pad and roll pad again, opening valve again as you finish rolling. Close the
valve once all air has escaped, and insert the pad into its stuff sack.
Care and Repair
To repair a leak, first clean and dry damaged area. Submerge the inflated pad in water
to help locate leaks. With pad deflated, adhere a fabric patch from the repair kit using a
urethane-based adhesive. This type of adhesive, such as Seam Grip® or Aquaseal®, can
be found at your local outdoor store. Spot clean pad with mild soap and water.
Use your mouth or Disco™ Pad Pump to inflate the pad until it is difficult to add air.
Twist the valve clockwise and push to close. [Hint: Push the valve in at any point
during inflation to prevent air loss.]
Remember to leave no trace. Before leaving your campsite take a thorough look
around making sure you have not left anything behind, out of place, or damaged.
To contact NEMO Customer Service
Email: [email protected]
Phone: 800-997-9301
©2013 NEMO Equipment, Inc.
ZOR ™ SERIES
1
2
3
4
5
®
INSTRUCTIONS FOR SETUP