Nor-Cal Intellisys Throttling Butterfly Valve - Manual

Intelli sys Throttling Butterfly Valve (TBV)
Quick-Start Guide
Covers all Throttling Butterfly Valves (TBV) and Low-Conductance Butterfly Valves (TBZ)
Nor-Cal Products, Inc. 1967 South Oregon St., Yreka, CA 96097 USA
LIT-TBV-QSG, 01/2005
Unpacking & Handling
Use care when unpacking an Intellisys Throttling Butterfly Valve. Aluminum surfaces can scratch easily and
Stainless Steel components are heavy. A static-safe, particle-free work surface is recommended. There is no
need to remove parts during installation or inspection.
Check The Package Contents:
•
Intellisys Throttling Butterfly Valve (TBV)
NOTE: IQ-series controllers are mounted directly to TBV’s
•
This Quick-Start Guide
Serial Label
A Serial Label on the bag shows the model number and serial number of your product. Additionally, Model,
Serial and Date Codes are engraved, and an inspection sticker is affixed to the side of the valve.
Warranty
Nor-Cal Intellisys Controllers and valves are warranted against defects and material workmanship for a period of
12 months after the date of shipment to the buyer. For complete warranty and Intellectual Property details,
please refer to the full manual.
Connections & Interfaces
Refer to the diagrams on the back of this sheet for Throttling Butterfly Valve connections.
Pre-Installation Functionality Check
WARNING: The valve plate movement presents a severe
pinching/crushing hazard. Please keep fingers, hands and other
objects away from the valve opening and associated moving parts.
Connect Power and Valve Cables
Connect the APC controller to the valve motor with a Nor-Cal TBV-CRD series cable. (NOTE: IQ-series valves
do not require a valve cable connection, as the motor is integrated into the controller.) Connect the controller to
an appropriate power source. Toggle the power switch (if applicable) or apply DC power from your source.
Initialize the Valve
From the tool software, send the appropriate initialization command to begin initialization. During Initialization,
the valve will complete a 15-second initialization sequence during which the valve plate will cycle back-and-forth
several times. The valve will eventually stop in the open position, unless specified otherwise by the firmware.
Open/Close Testing
Verification of the system communications can be done by toggling the “OPEN / CLOSE” switch (if available) on
the controller front panel, or sending the appropriate command from the tool software. If the valve does not
operate as described, please contact Nor-Cal technical support.
Obtaining Complete Manuals
To download complete manuals for Intellisys TBV Valves, please visit www.n-c.com . Click Support, choose
Product Documentation Downloads from the drop-down menu, and pick Downstream Pressure Control and
locate document under Manuals at the left.
Serial Label