P.I. Engineering PS/2 to USB Adapter - Manual (Page 3)

Toubleshooting
The Y-mouse uses the standard USB mouse and keyboard drivers already on the
operating system. Special drivers or software for PS/2 keyboards and pointing devices
may not be supported. Test each device independently without the Y-mouse to confirm
that each will operate on the computer. Please contact our technical support department
for help:
E-mail: [email protected]
Phone: (517) 655-5523 ext.19
Certifications
P.I. Engineering adapters are certified lead free.
This product should not be disposed of via the normal
household waste stream. To prevent possible harm to the
environment or human health please separate this product
from other waste streams to ensure that it can be recycled
in an environmentally sound manner.
For more details on available collection facilities please contact your local government
office or the retailer where you purchased this product. This information only applies to
customers in the European Union. For other countries, please contact you local
government to investigate the possibility of recycling your product.
FCC and CE Certified
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
residential installation. This equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with the instruction manual may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user in encouraged to try to correct the interference by one
or more of the following measures:
1
Reorient or relocate the receiving antenna.
2 Increase the separation between the equipment and the receiver.
3 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4 Consult the dealer or an experienced radio TV technician for help.
Any changes or modifications not expressly approved by the manufacturer could
void the user’s authority to operate the equipment.