Palram SUNTU BH (Beehive) - Manual (Page 3)

SUNTUF® Technical Guide
Profile: Iron 76/18 (Sinus)
26/02/2009 3
ƒ Important Notes
ƒ Use only PALRAM approved accessories, including EPDM rubber
washers, silicones, sealing tape, closure fixtures etc.
ƒ For clear SUNTUF onto wooden purlins, apply white acrylic paint, or
aluminum tape, in order to prevent over-heating of the purlins.
Cutting / Sawing tools
ƒ Table or Portable circular saw with small teeth.
ƒ Jigsaw.
ƒ When Sawing use high blade speed and slow feed rate.
ƒ Support the sheet in the vicinity of the cut and clean dust and
splinters away.
Fastening Tips
ƒ Use adjustable electric screwdriver.
ƒ The screw must be installed perpendicular to the SUNTUF sheet.
ƒ Important: Do not over-tighten.
Safety
ƒ Do not step directly on the panel.
ƒ Use stepping boards.
ƒ Work according to local safety regulations.
Handling and Storage
ƒ Store in a shaded place, protect from direct sunlight and rain.
ƒ Avoid covering the sheets with heat absorbing materials.
ƒ Avoid contact or environment of chemicals.
ƒ Protect the sheets from any physical damage.
Inasmuch as PALRAM Industries has no control over the use to which others may put the material, it does not guarantee that the same results as
those described herein will be obtained. Each user of the material should make his own tests to determine the material’s suitability for his own
particular use. Statements concerning possible or suggested uses of the materials described herein are not to be construed as constituting a license
under any PALRAM Industries patent covering such use or as recommendations for use of such materials in the infringement of any patent. PALRAM
Industries or its distributors cannot be held responsible for any losses incurred through incorrect installation of the material. In accordance with our
company policy of continual product development you are advised to check with your local PALRAM Industries supplier to ensure that you have
obtained the most up to date information.