Palram SUNOPA - Manual

SUNOPAK® 76 / 18 (Greca/ Trapeze)
Installation Guide
1
Profile Dimensions
Profile
(mm)
Thickness
(mm)
Length
(m)
Width
(mm)
Effective
Width (mm)
Number of
Corrugations
Side-Lap
(%)
76/18 1.0 1.5-11.6 1155 1064 15.5 7.8
Load / Span Data
Load
(Kg/m 2 )
Maximum purlin Span
Slope of 5% (mm)
Maximum purlin Span Slope
of 10% (mm)
50 1000 1100
75 900 1000
100 800 900
125 700 800
The dimensions depicted do not supersede the requirements of local construction codes.
In vertical walls the spans can be increased by 10%.
Minimum recommended slope for a new roof – 5%.
Maximum recommended sheet length – 7.0 m.
Safety
Do not step directly on the sheets - before, during or after installation.
Work according to local safety regulations.
Use stepping ladder or crawling boards.
Positioning
The sheets must be laid on the roof against the primary direction of wind and rain.
Use 1 1 /
2
corrugations Side Lap.
The SUNOPAK sheets must be installed without any stresses.
Curved Roof Fastening
Minimum curving radius along the corrugations - 4.0 m.