Paradigm Soundtrack 2 System - Manual (Page 10)

IR Learning Codes
Your system is capable of learning certain codes from remote controls
you already own, for example, the volume code from your TV’s remote.
Each code must be programmed in separately. To program, follow the
steps below:
1. Press and hold for 3 seconds the button on the soundbar’s Top
Panel Controls for the desired function to be programmed
(eg. volume, mute, on/off).
2. The soundbar’s LED will start to flash indicating that the system is
now in ‘IR learning’ mode.
3. Aim alternative remote control at the front of the soundbar and
press its corresponding function button. The blue LED rapidly
flashes 4 times to indicate that the IR code has been ‘learned’, it then
returns to a solid blue.
4. Repeat from Step 1 to program each function.
NOTE ABOUT MUTE: To learn a MUTE command from a remote
control you already own, press the Sync button on top panel of the
soundbar for 3 seconds then move to Step 2 above.
NOTE ABOUT IR CODES: Your existing cable/satellite box remote
control or TV remote control may use a code that the system cannot
learn. In these instances, you will have to use the remote control that
came with your system or use a universal or learning remote control.
CONNECTION
For quick system setup and connection refer to the
instructions in the Set-Up Guide included.
SETTING UP THE SOUNDBAR
Refer to the Set-Up Guide included for detailed instructions on all of
the following.
a) Setup
b) LED functionality
c) Establishing a Bluetooth Connection
SETTING UP THE SUBWOOFER
(Shown) Back panel of Subwoofer.
See page 8 for description of
numbered functions.
1
2
3
4
EN EN
EN – 7