Control – Paradigm Soundtrack System User Manual

Page 9

Advertising
background image

Step 4
a) If a wall stud is found, drill a pilot hole into the stud at each mark,

then move to Step 5. OR

b) If no stud is found, install wall anchors at each mark following the

instructions for the type of wall anchor you are using. CAUTION:
We strongly recommend contacting a professional contractor
for this type of installation. Every effort has been made to provide
accurate and error-free installation instructions. Paradigm
Electronics Inc. disclaims liability for difficulties that may arise
from the misinterpretation of information contained in these
instructions.

Step 5
Using the screws, attach the first wall bracket
to the wall. DO NOT completely tighten
screws (Fig. 5).

Step 6
Repeat all steps for the second bracket.
Use a level to make sure the brackets are
completely straight before tightening screws.


IMPORTANT: Attach audio cables BEFORE mounting soundbar
to wall brackets. See Set-Up Guide for how to attach cables.


Step 7
Move soundbar into place directly over brackets and gently push it to the
wall making direct contact with brackets. You will hear a CLICK as each
bracket makes contact with the soundbar. DO NOT release soundbar
from your grasp until you hear those two clicks.

CONTROL

Remote Control
The supplied remote requires one lithium battery (included). The
remote turns the power on and off, switches between inputs and
controls volume.

Battery Installation
Follow the diagram on
the back of the Remote
for correct insertion.
+ to + andto -.


Onboard Interface

Press to synch
soundbar and

subwoofer

Press to

select

Input

Press to turn

system

on and off

6

Press to

select

Input

Press and

hold for

increased

volume

Press to

silence the

system.

Press again

to restore

sound

Press and hold

for decreased

volume

Press

to turn
system

on & off

IMPORTANT:
If you lose the remote
contact Paradigm at
1-905-696-2868 to
purchase a new one.
Loss of remote is
not covered under
Paradigm warranty.

Press and
release to

decrease

volume

Press and
release to

increase

volume

Fig. 5

FINAL_SoundtrackManual_ENG_FRE_SPA_READER_SPREADS.indd 6

12-10-12 12:01 PM

Advertising