ParkZone PKZU1180 - Manual (Page 11)

20
EN
DE
FR
IT
21
EN
DE
FR
IT
Replacement Parts
PKZ3001. . . . . . . . . . . . . . 3.7V 70mAh Li-Po Battery
PKZ3240. . . . . . . . . . . . . . DC 3.7V LiPo Charger
PKZ3302. . . . . . . . . . . . . . Propeller with Spinner (140mm x 45mm)
PKZ3307. . . . . . . . . . . . . . Tail Skid: Vapor/Night Vapor
PKZ3316. . . . . . . . . . . . . . Main Motor: Vapor/Night Vapor
PKZ3322. . . . . . . . . . . . . . Pushrod Set: Vapor/Night Vapor
PKZ3327. . . . . . . . . . . . . . Gearbox without Motor: Vapor/Night Vapor
PKZ3328. . . . . . . . . . . . . . Prop Shaft with Gear (2): Vapor/Night Vapor
PKZ3341. . . . . . . . . . . . . . Transmitter, 2.4GHz with Spektrum DSM2
PKZU1106 . . . . . . . . . . . . Main Landing Gear Set: Night Vapor
PKZU1120 . . . . . . . . . . . . Main Wing with Lights: Night Vapor
PKZU1124 . . . . . . . . . . . . Horizontal Stabilizer: Night Vapor
PKZU1125 . . . . . . . . . . . . Rudder: Night Vapor
PKZUA1151 . . . . . . . . . . . 3-Ch Rx/ESC with LED port, DSM2
PKZU1161 . . . . . . . . . . . . Fuselage with Electronics: Night Vapor
PKZU1170 . . . . . . . . . . . . Replacement Airframe (no electronics or motor): Night Vapor
PKZU1167 . . . . . . . . . . . . Bare Fuselage: Night Vapor
EFLH1066 . . . . . . . . . . . . . Replacement Servo Mechanics
EFLH1067 . . . . . . . . . . . . . Replacement Servo Retaining Collars
Optional Parts
PKZ3052. . . . . . . . . . . . . . Battery Connector with Wire
EFLB1201S . . . . . . . . . . . . 120mAh 3.7V 14C Li-Po Battery*
EFLB1501S . . . . . . . . . . . . 150mAh 3.7V 12C Li-Po Battery*
EFLC1004 . . . . . . . . . . . . . 4-Port 3.7V Li-Po Charger
EFLC1005 . . . . . . . . . . . . . AC to 6V DC Adapter (United States)
EFLC1005AU. . . . . . . . . . . AC to 6V DC Adapter (Australia)
ELFC1005EU . . . . . . . . . . . AC to 6V DC Adapter (Europe)
EFLC1005UK. . . . . . . . . . . AC to 6V DC Adapter (United Kingdom)
SPM6825 . . . . . . . . . . . . . Linear Servo Reverser
SPMR5500 . . . . . . . . . . . . DX5e 5-Channel Transmitter Mode 2
SPMR55001 . . . . . . . . . . . DX5e 5-Channel Transmitter Mode 1
SPMR6600 . . . . . . . . . . . . DX6i 6-Channel Transmitter Mode 2
SPMR66001 . . . . . . . . . . . DX6i 6-Channel Transmitter Mode 1
SPMR6600E . . . . . . . . . . . DX6i 6-Channel Transmitter Mode 2 (Europe)
SPMR66001E . . . . . . . . . . DX6i 6-Channel Transmitter Mode 1 (Europe)
SPMR7700 . . . . . . . . . . . DX7 7-Channel Transmitter Mode 2
SPMR77001 . . . . . . . . . . . DX7 7-Channel Transmitter Mode 1
SPMR7700E . . . . . . . . . . . DX7 7-Channel Transmitter Mode 2 (Europe)
SPMR77001E . . . . . . . . . . DX7 7-Channel Transmitter Mode 1 (Europe)
*Note: For longer flight times try using a larger capacity high-quailty battery such as the E-Flite
120mAh (EFLB1201S) or 150mAh (EFLB1501S) Li-Po batteries.
Troubleshooting Guide
If you have any problems with setup or programming that cannot be fixed by the Troubleshooting Guide,
please see page 23 and call the appropriate Horizon Product Support office.
Problem Possible Solutions
Aircraft will not “throttle up” but all
other controls seem to function.
Lower throttle trim and/or throttle stick to their lowest settings.
Reverse throttle channel on specific transmitter if
applicable.
Propeller or motor shaft is broken. Replace with Prop with Spinner (PKZ3302) or Prop Shaft
(PKZ3328).
Aircraft appears to show significant
decrease in flight time.
Recharge flight battery completely.
Replace AA batteries in charger or use AC to 6V DC Adapter and
recharge flight battery completely.
Replace PKZ3001 battery and read the “Battery Warnings and
Guidelines” section of manual.
Charger light stays on after Li-Po
battery is disconnected, or remains
on for longer than 40 minutes when
charging.
Replace AA batteries in charger.
Aircraft appears to have less power. Lubricate the bushings of the gearbox.
Lubricate the bushings of the motor.
In cold weather, prior to flight, make sure the flight batteries
are warm.
Use a larger capacity battery (unless it will not physically fit
without modification).
LED on aircraft remains flashing and
cannot be controlled by transmitter.
Unplug and reconnect flight battery.
Move transmitter (powered on) a few feet from the aircraft prior
to reconnecting the flight battery.
Move transmitter and aircraft away from large metal objects
when binding/linking.
Rebind the aircraft to the desired compatible transmitter.
LED on aircraft will not illuminate. Replace with Main Wing with Lights (PKZU1120)
Aircraft appears to roll, yaw and pitch
towards a certain direction.
Trim control surfaces using the transmitter until the aircraft no
longer moves that direction.
Controls appear to be reversed after
binding to a different transmitter.
Read the “Control Test” section of manual.
Aircraft does not function after
connecting flight battery and the
aircraft smells burnt.
Replace the PKZUA1151 receiver board and check for correct
polarity when connecting the flight battery.