Peachtree Audio musicBox - Manual (Page 10)

9
U s e f u l
T i p s
At Peachtree Audio we think that products should be easy to use. Therefore, we don’t require
any custom USB drivers or software programs in order to listen to your music from your computer.
The musicBox’s USB audio input is used to take music files from your computer’s hard drive and
play them back with superb fidelity.
While some of the wording and steps vary somewhat between Macintosh computers and PCs,
the basic instructions are very similar.
USB Connections
PC
Connect the USB terminal on the musicBox to a USB connection on your computer.
Your computer will “see” the USB Audio DAC inside the musicBox. You may get a “USB AUDIO
DAC” pop-up box but it’s not necessary.
Right click the speaker icon on the bottom of your screen.
Select “Audio” tab.
Using the drop-down box choose USB AUDIO DAC.
Click OK.
Launch Music Program and play.
Mac
Later Mac setup may vary but the basic instructions are outlined below.
Click on to System preferences.
Click on to the speaker icon.
Under the sounds tab you should see a window that offers USB Audio DAC. Click on to USB
Audio DAC.
Launch iTunes and enjoy your music.
Once you do this setup your computer should recognize the USB Audio DAC and default to it
when plugged in. If you unplug the USB connections and reboot your music before re-connecting
first, you may find that you have to go back through some steps, This is not unusual.
1)
2)
3)
4)
5)
6)
7)
1)
2)
3)
4)
5)