Peachtree Audio deepblue2 - Manual (Page 9)

9
Troubleshooting & Specifications
I Don’t Hear Anything Playing
Make sure the deepblue 2 is plugged in and turned on (indicated by all of the
top panel buttons lit white).
Check that the correct input is selected; Bluetooth (Bluetooth LED blue),
AUX (Input LED lit blue) or OPT (Input LED lit white).
If the Bluetooth LED is flashing blue, the input is selected but a Bluetooth
device is not currently connected. Check the following next:
Make sure Bluetooth is enabled on your device.
Make sure your Bluetooth device is within ~33 feet of the deepblue2. Move
closer or adjust the position of the deepblue2 to establish a connection.
Make sure music is playing on your device (not paused) and that the volume
on the device is not muted or set to a very low level. Many devices will pause
playback if the Bluetooth connection is lost.
If AUX is selected, make sure the wired connection is fully inserted on the
connected device and the deepblue2. If the connection is ok, check the vol-
ume level of the connected device (if using a headphone output) to make
sure it is not muted or set to a very low level.
If OPT is selected, make sure the wired connection is fully inserted on the
connected device and the deepblue2. If the connection is ok, check the volume
level of the connected device (if using a device with a built-in volume control) to
make sure it is not muted or set to a very low level.
Make sure the volume of the deepblue2 is set to a comfortable listening level.
Specifications:
• Acoustic Design:
(2) 1-inch high frequency drivers
(2) 3-inch midrange frequency drivers
(1) 6.5-inch low frequency driver
Acoustically sealed cabinet
• Power Amplifer: 440 Watts
• Inputs:
aptX Bluetooth wireless with up to 5 connected devices
Optical Digital Audio (Toslink)
Line-level Analog Audio (3.5mm)
• Dimensions (H x W x D): 9.1 x 14.2 x 6.5 (inches) / 230 x 360x 164 (mm)
• Weight: 16 pounds / 7.3 kg
• AC Input: 100-240V 50/60Hz