Peg-Perego Vela Easy Drive - Manual (Page 12)

- 12 -
the hood off (fig_b).
7 5-POINT SAFETY HARNESS: to attach the
safety harness, insert the two buckles of the
waist strap (with shoulder straps attached)
into the leg divider strap until it clicks into
place (fig_a). To release, press both sides of
the buckle and pull the waist strap to the
sides at the same time (fig_b).
8 To secure the child with the safety harness,
insert the shoulder strap buckle in the special
holder on the backrest (fig_a) and, after
fastening the harness, detach the buckle from
the backrest to allow the child more freedom
of movement (fig_b). Position the shoulder
strap buckle just below the child's shoulders
to ensure the straps remain in place without
slipping (fig_c). To tighten the waist strap, pull
on both sides in the direction of the arrow
(fig_d). To loosen it do the opposite. The waist
strap can be tightened as far as the safety
lock (fig_e).
9 ADJUSTING THE BACKREST: To recline the
backrest, lower the backrest-adjusting button
while pushing it down (fig_a). To lift the
backrest, pull up the backrest-adjuster (fig_b).
10 CUP HOLDER: Fit the cup holder by fastening
it until it clicks into place (fig_a). Fastened cup
holder (fig_b).
11 BRAKE: To set the brakes on the stroller, push
down both levers on the rear wheels with
your foot. Always set the brakes when the
stroller is not moving.
12 FRONT SWIVELLING WHEELS: for front
swivelling wheels, raise the lever located on
the wheels (fig_a), for fixed wheels, position
the wheel as illustrated in the figure and
lower the lever (fig_b).
13 FRONT WHEEL RELEASE: to release the front
wheels, press the button (fig_a) and slide off
the wheels (fig_b).
14 To remove the rear wheels, press the small
button (fig_a) while pushing down the
wheels to remove them completely (fig_b).
15 FOLDING UP THE STROLLER: Before folding
up the stroller, close the hood if attached.
Lift the lever on the handlebar (fig_a) and
turn it forwards (fig_b); push the backrest
and the hood towards the stroller and lower
the handlebar until it returns into its housing
(fig_c). Check the safety hook to ensure that
the stroller is correctly folded up (fig_d).
16 When folded up, the stroller stands on its own
and can be carried by the handle.
17 REMOVABLE LINING: To remove the lining
from the stroller, first of all remove the hood,
then remove the little cover on the side by
pressing on it (fig_a). Push the pin upwards
and then outwards (fig_b). Slip the pin out
of the hole in the sack (fig_c). Repeat on the
other side.
18 To unfasten the sack from the seat, remove
the leg divider from underneath (fig_a) and
unbutton the sack (fig_b). Unfasten the strap
on both sides (fig_c) and pull the sack off.
GANCIOMATIC SYSTEM
Ganciomatic is the practical, fast system
for attaching the Primo Viaggio car seat to
the stroller. The car seat is fitted with the
Ganciomatic System, and is sold separately.
19 STROLLER GANCIOMATIC FASTENERS: To raise
the Ganciomatic fasteners on the stroller, pull
the sack up in the seat corners and lift the
two fasteners. They will automatically move
outwards (fig_a). To lower the Ganciomatic
fasteners, push them inwards and then down
(fig_b).
20 STROLLER + CAR SEAT: To fasten the car seat
to the stroller: set the brake on the stroller,
remove the hood, completely lower the
backrest and raise the Ganciomatic fasteners.
Place the car seat, facing the adult, on the
stroller and push down until it clicks into
place. Do not remove the front bar from the
stroller when attaching the car seat. See the
car seat’s user manual for instructions on how
to detach it from the stroller.
ACCESSORY
21 BORSA. Diaper-Changing Bag with pad for
changing the baby. Attaches to the stroller.
22 RAIN CANOPY: The rain canopy can be
attached to the hood.
SERIAL NUMBERS
23 VELA carries information on its date of
manufacture under the seat.
_ Product name, date of manufacture and serial
number of the product.
This information is essential in the event of
any complaints.
CLEANING AND MAINTENANCE
PRODUCT MAINTENANCE: protect from the
weather: water, rain, or snow; prolonged
and continuous exposure to bright sunlight
may give rise to colour changes of various
different materials; store this product in a dry
place.
CLEANING THE CHASSIS: periodically clean all
plastic parts with a damp cloth. Do not use
solvent or similar cleaning products; keep
all metal parts dry to prevent rusting; keep
moving parts clean (adjustment mechanisms,
locking mechanisms, wheels, ...) and free of
dust and sand and, if necessary, lubricate with
light machine oil.
CLEANING THE RAIN CANOPY: wash with
a sponge and soapy water; do not use
detergents.
CLEANING FABRIC PARTS: brush fabric parts