Unpacking the conveyor, Unpacking the printer cont, Unpacking the feeder – Pitney Bowes DP50S Color Printer User Manual

Page 2: Installing the toner, Loading paper

Advertising
background image

Page 2 of 4

Quick Installation Guide

Impressia Digital Multi-Media Press

Next Sheet

Complete hardware setup for the Impressia

Unpacking the Conveyor

Place the conveyor on the left side

of the printer and secure with the two

locking knobs from the bottom of the

conveyor tray.

Unpacking the Printer cont.

Unbox the conveyor with two people.

Unpacking the Feeder

Refer to the packaged instrcutions for complete setup.

Place the conveyor tray on the left side

of the printer and secure with the four

thumb screws.

Refer to the packaged instrcutions for complete setup.

• The conveyor will need some assembly during setup.

• Follow the instructions that are packaged with the

conveyor.

Pull out the tapes horizontally. Be sure

to pull out all four strips of tape.

Pressing both sides, firmly close the

inner cover.

Turn the two green levers clockwise to

lock the cover.

• To avoid malfunctions, be sure to remove all four

strips of tape from the photo conductor unit.

• Removed tape is dirty. Be careful not to let it touch

your hands or clothes.

Using the alignment rail on the right side

of the feeder, slide the feeder into the

open slot on the printer and screw the

locking knob in place to secure the

feeder's position.

Unbox the feeder with two people.

Refer to the packaged instrcutions for complete setup.

Place the feeder on the right side of the

printer stand.

Refer to the packaged instrcutions for complete setup.

• The feeder will need some assembly after setup.

• Follow the instructions that are packaged with the

feeder.

Shake the toner up and down five or six

times

Even distribution of toner within the cartridge

imroves print quality.

With the label facing up, fully insert the

magenta toner into place, keeping the

container horizontal.

Use the same procedure to insert the

remaining toner. From the right: magenta

(M), cyan (C), yellow (Y) and black (K).

Close the front cover.

Installing the Toner

Take the toner containers out of the box.

Loading Paper

Carefully pull out tray 1 until it stops.

When printing using the bypass tray, do not pull out

the paper tray.

Pinch the green clip on the end guide

( ), and adjust it to A4 size ( ).

Confirm that there are no gaps between the paper

and paper guides. If there are gaps, adjust the guides.

Align and load paper in the tray with the

print side up.

Warning

• Do not incinerate used toner or toner container.
Toner dust might ignite when exposed to an open

flame.

• Dispose of used toner containers in accordance
with local regulations.
• Do not store toner, used toner, or toner containers
in a place with an open flame. The toner might
ignite and cause burns or a fire.

Caution

• Keep toner (used or unused) and the toner
container out of reach of children.
• If toner or used toner is inhaled, gargle with plenty
of water and move into a fresh air environment.
Consult a doctor if necessary.
• Avoid getting toner on your clothes or skin when
removing a paper jam or replacing toner. If your
skin comes into contact with toner, wash the
affected area thoroughly with soap and water.
• If toner or used toner gets into your eyes, flush
immediately with large amounts of water.
Consult a doctor if necessary.
• If toner or used toner is swallowed, dilute by
drinking a large amount of water. Consult a

doctor if necessary.

• If toner gets on your clothing, wash with cold
water. Hot water will set the toner into the fabric
and may make removing the stain impossible.

Caution

• Do not pull out the paper tray forcefully. If you do,
the tray might fall and cause an injury.

• To avoid paper jams, make sure paper is not stacked

higher than the upper limit mark inside the paper tray.

Paper misfeeds might occur.

• Do not mix different types of paper in the same

paper tray.

• When you first use this printer, use the toner

packaged with the printer.

• The number of pages that can be printed using the

starter toner supplied with this printer is approximately

10,000 pages for black and 8,000 pages for cyan,

magenta and yellow. (A4/Letter 5% test chart; 3 pages/

job; Cyan, Magenta and Yellow: color printing only.)

• The actual number of printable pages varies depending

on the image volume and density, number of pages

to be printed at a time, paper type and paper size

used, contents of print images, and environmental

conditions such as temperature and humidity.

• Toners purchased from Pitney Bowes will have a

print volume of pages: 20,000 pages (black) and 15,000

pages (color). (A4/Letter 5% test chart; 3 pages/job;

Cyan, Magenta and Yellow: color printing only.)

• The actual number of printable pages varies depending

on the image volume and density, number of pages

to be printed at a time, paper type and paper size

used, contents of print images, and environmental

conditions such as temperature and humidity.

Advertising
This manual is related to the following products: