Pitney Bowes MapInfo Stratus - Manual (Page 48)

Frequently Asked Questions
I just zoomed out and the legend control now shows a layer as disabled
In MapInfo Stratus the administrator can determine the zoom levels at which map layers are displayed.
This is called "Zoom Layering". When a map layer becomes disabled you need to zoom in (or in some
cases zoom out) to make the layer visible. Normally, layers that show very detailed information are
enabled only when you zoom in.
Where is the zoom layering stored?
The zoom layering is stored as the part of layer definition, and cannot be viewed or changed by users
after it has been created and uploaded into MapInfo Stratus.
Why are disabled layers not getting reflected in the PDF print?
This is an expected behavior. The layers which are disabled are not shown on the map or the print PDF.
You can zoom in to show layers for both.
MapInfo ™ Stratus 42 48
Frequently Asked Questions