Moving table to the 0° cut-off position, Attaching extension table and fence slide, Moving cuttinghead to the up position – Delta 36-255L User Manual
Page 9
9
MOVING TABLE TO THE 0° CUT-OFF
POSITION
1.
Rotate locking knob (A) Fig. 6 counter-clockwise as
far as it will go. Depress lever (B) and rotate table (C)
to the 0° straight cut-off position, release lever (B),
and tighten locking knob (A).
2.
Fig. 7 illustrates the table (C) in the 0° straight cut-off
position.
3.
For proper operation and adjustment of the table,
refer to sections, “ROTATING TABLE FOR MITER
CUTTING” and “ADJUSTING SLIDING FIT
BETWEEN MOVABLE TABLE AND BASE.”
ATTACHING EXTENSION TABLE AND
FENCE SLIDE
1.
Attach flat washers to the two 5/16-18 x 3/4” screw
assemblies (A) Fig. 7A, and thread into the threaded
holes on left side of the saw.
NOTE: Turn the screws only a few threads into the holes
at this time.
2.
Attach the table extension (B) Figs. 7A and 7B, to left
side of saw table, making sure groove of table
extension (B) is inside flat washers (C) as shown in
Fig. 7B.
3.
Use a straight edge (C) Fig. 7C, to make the
extension table (B) even with saw table (D), and
tighten the two screws (C) Fig. 7B.
Fig. 6
Fig. 7
C
A
Fig. 7A
B
A
Fig. 7B
B
C
B
C
Fig. 7C
C
D
B
Fig. 5
B
A
MOVING CUTTINGHEAD TO THE UP POSITION
1.
Pull out cuttinghead lockpin (A) Fig. 4, and move the cuttinghead (B)
to the up position.
2.
Fig. 5, illustrates the lockpin (A) pulled out and the cuttinghead (B) in
the up position.