Portable Winch Gas-powered pulling/lifting winch PCH1000 - Manual (Page 19)

19
IMPORTANT: D
ON’T GO OVER THE ROPE ENTRY PULLEY OF THE
WINCH WITH THE ROPE (FIGURE 2 BELOW) AS IT WILL CREATE FRICTION AND WILL
REDUCE LIFTING CAPACITY. GO UNDER THE ROPE ENTRY PULLEY (FIGURE 1 BELOW).
IN THIS CASE, THE ROPE ENTRY PULLEY OF THE WINCH WILL NOT BE USED.
IMPORTANT: AFTER PULLING FOR A FEW SECONDS, RELEASE THE
TENSION AND CHECK THE SOLIDITY OF THE INSTALLATION AND TIGHTEN THE SLING
OF THE TREE/POLE MOUNT AGAIN.
3.3.6 Using the vertical pull winch support (PCA-1264) with square tubing 50 mm (2'')
(PCA-1267)
ONLY USE VEHICLES EQUIPPED WITH CLASS III TOWING HITCHES.
NEVER ATTEMPT TO LIFT MORE THAN THE RATED LIFTING
CAPACITY OF 250 KG (550 LB).