Qsonix Q110 - Manual (Page 8)

8
Connecting your Qsonix System and Touchscreen Controller
Please use the following diagram to assist you in making the necessary audio, video, power and network connections.
Step by Step cabling guidelines
1. Place the touchscreen controller on a flat surface such as a tabletop, on top of the Qsonix system or other
suitable location. Tilt the panel to expose the row of connectors located in the lower rear panel of the
touchscreen. (Unit can be wall-mounted with optional mounting kit and professional installation – contact
your Qsonix dealer)
2. Connect one end of the blue D-sub 15-pin VGA signal cable to the “Video” connector on the Qsonix system
and the other end to the “Video/VGA Input” connector on the back of the touchscreen.
3. Connect the green DB-9 (square) end of the RS-232 signal cable to the “Touchscreen” connector on the back
of the Qsonix system, and the other end to the serial/touchscreen connector on the back of the touchscreen.
4. Connect the Network port on the rear of the system to your Network router, hub or switch using a CAT5
Ethernet cable. (You may also use a 3rd party passive Wireless bridge)
5. Connect one end of the AC power cable to the Power connector on the rear of the Touchscreen Controller
and the other end into an available power outlet/source.
6. Plug the other provided power cable into the power supply/connector on the rear of the system, and the
other to an available power outlet/source.
7. Using the supplied audio cables, connect the appropriate analog and digital outputs to the line-level inputs
of your amplifier, preamplifier or powered speakers.
Note: The Q110/Q105 can only operate in four or two-zone mode respectively when connected
using analog outputs.