REFCO OCTA-WIRELESS - Manual (Page 16)

OCTA-WIRELESS User’s Guide English
14
Restoring Factory Calibration
If you make a mistake recalibrating the OCTA-WIRELESS, you can always restore the
factory calibration (and factory defaults) of the scale.
To restore the factory settings perform the following steps:
1. Turn the power to the OCTA-WIRELESS off.
2. Remove any objects from the platform.
3. While holding , press and release . The OCTA-WIRELESS will turn on and beep
10 times. The factory settings are now restored.
4. Refer to the Quick Start section above for setting the desired Units and Resolution.
5. Calibrate
Sound
As delivered from the factory, the OCTA-WIRELESS beeps when turning on and when keys
are pressed. This sound can be muted as follows:
1. Make sure the power is on.
2. While holding , press . The musical symbol on the left of the display will turn
off to indicate that the sound has been muted.
Repeat steps 1 and 2 to turn the sound back on.
NOTE: The Mute function only affects the power-on and key-press beeps. It has no effect
on the alarm.