Seite3 – REFCO YUMA User Manual

Page 3

Advertising
background image

SAFETY INSTRUCTIONS AND WARNING
Under normal use this equipment requires no user intervention. Installation, both fixing
and electrical, and maintenance work shall be carried out only by the manufacturer or
by its service center or in any case by a person having similar skills, so as to prevent
any risk. Electrical installation of equipment shall be in compliance with these
installation instructions and with all National and Local Regulations for Electrical Safety.

To reduce the risk of fire, electrical shock and injury to persons, the following safety
instructions shall be used:

Ÿ

This pump is intended for indoor use with water only (max 25°C).

Ÿ

This pump is NOT SUBMERSIBLE.

Ÿ

Disconnect ALL power supplies before starting installation, connection or
maintenance work.

Ÿ

This pump is provided with a grounding conductor. To reduce the risk of electric
shock, be certain that it is connected only to a properly grounded, grounding type
receptacle.

Ÿ

All interconnecting tubes and cables should be confined within the air conditioning
unit, or enclosed in any way

Ÿ

During electrical installation, make sure this condensate pump is connected to a
circuit having switch with contact separation in all poles that provide full
disconnection from the power supply under over-voltage categories III

Ÿ

During electrical installation, a fuse non-time delay (rated 250V 1A), shall be fitted
into the line, supply side, see electrical installation section.

Ÿ

The power cord is not replaceable. If the power cord is damaged then the entire
pump must be replaced.

Ÿ

Children should be supervised to ensure that they are not left unattended in the area
where the pump is in use.

Ÿ

Children or persons with reduced physical, sensory or mental capabilities which limits
their ability to use the appliance should have a responsible person to instruct them in
its use.

Do not allow any chemicals to come into contact with this pump. Remove the pump
from the system before using cleaning fluid or any other chemicals. Flush the system
with clean water before re-connecting the pump.
All fittings on this pump are designed to be finger-tight. The use of tools to attach
pipework may result in damage to the pump.

In any installations where property damage and/or personal injury might result from an
inoperative or leaking pump, it is strongly recommended that the alarm relay should be
used to operate an alarm and/or switch off the air conditioning unit.

GB

2

Advertising