Remy Dash Mount Magnetic Switch (Relay) 10511610 User Manual
Page 2
NOTICE
- Only licensed Remy International, Inc. product and component parts should be used, and the use of other parts or modifications not approved
by Remy International, Inc. will void all applicable warranties. The failure to carefully follow these Installation Instructions, set forth above, will void all
applicable warranties. DELCO REMY is a registered trademark of General Motors Corporation, licensed to Remy International, Inc. Pendleton, IN 46064.
©
2012 Remy International, Inc. All rights reserved
2
Technical support: USA 800 854 0076, Mexico 01 800 000 7378, Brazil 0800 703 3526, South America 55 11 2106 6510 or visit
delcoremy.com
SECTION D: When installing continuous duty magnetic switch
(relay) model 1114223 or 1119841 on vehicle having 12-volt
system, or with resistor/s on vehicle having 24 -, 30- or 32-volt
system
1. Mount the switch using suitable bolts, nuts and lock washers.
2. Stranded copper wire of adequate size to carry the current
should be used, and all connectors should be crimped and
soldered to the wiring.
3. The following chart indicates the proper resistor to be used
in a 24-, 30- or 32- volt system for each magnetic switch. The
resistor is available at any AC-Delco Distributor.
* Current capacity in continuous amperes through large terminal of
switch.
** Use second resistor only with 1119841 on 24-volt system.
4. Make connections as shown in Figure 3 for 12 -volt system, or
as shown in Figure 4 for 24-, 30- or 32-volt system
.
SWITCH
SYSTEM
RESISTER
CURRENT
MODEL
VOLTAGE PART NUMBER
CAPACITY
1114223
12
None
50*
1114223
24
1970166
50*
1114223
30, 32
1970168
50*
1119841
12
None
500*
11.19841
24
1970166** (use
two)
500*
1119841
30, 32
1970166
500*