Rocktron Utopia B100 - Manual (Page 38)

38
FUNCTION PARAMETER LIST RANGE
(via FUNCTION SELECT) (via PARAMETER SELECT) via PARAMETER ADJUST)
DELAY DELAY (Delay Status) Muted, Active
MUTE TYPE (Mute Type Status) Pre, Post, Both
DELAY LVL (Delay Level) OFF to +4(dB)
MIX (Source 1/Source 2 Mix Level) S1 <0 to 100> S2
SOURCE 2 (Source 2 Select) DIRECT, Voice 2
DLY HF DAMP (Delay High Frequency Damping) 0 to 99
OUT LEVEL 1 (Delay 1 Level) OFF to +4(dB)
PAN 1 (Delay 1 Panning) L <0 to 100> R
DLY TIME1 (Delay 1 Length) 0 to 2000ms
REGEN 1 (Delay 1 Regeneration) OFF to +4(dB)
OUT LEVEL 2 (Delay 2 Level) OFF to +4(dB)
PAN 2 (Delay 2 Panning) L <0 to 100> R
DLY TIME2 (Delay 2 Length) 0 to 2000ms
REGEN 2 (Delay 2 Regeneration) OFF to +4(dB)
REVERB REV INPUT (Reverb Input Status) Muted, Active
MIX (Direct/Delay Mix Level) Dir <0 to 100> Dly
REVERB LVL (Reverb Signal Level) OFF to +4(dB)
REV DECAY (Reverb Decay Length) 0 to 99
REV HF DAMP (Reverb High Frequency Damping) 0 to 99
CONFIG SELECT PRE CHR DL REV
PRE FLA DL REV
PRE TRE DL REV
PRE PSH DL REV
WA PRE DL REV
PHA PRE DL REV
TITLE EDIT XXXXXXXXX
PEDAL NUMB 1 OFF, PED, ADJ
CONTROLLERS PARA1 Any parameters available in this
confi guration can be selected.
ULIM C1 Any range in PARA1's selection
can be used.
LLIM C1 Any range in PARA1's selection
can be used.
NUMB 2 OFF, PED, ADJ
PARA 2 Any parameters available in this
confi guration can be selected.
ULIM C2 Any range in PARA2's selection
can be used.
LLIM C2 Any range in PARA2's selection
can be used.
PEDAL STATUS RUN STAT (Pedal Running Status On or Off) OFF,ON
PEDAL VOLUME 0 to 127
FACTORY RESTR X to X (Restore a single preset) 1 to 1, 2 to 2, 3 to 3, etc.
RESTORE ALL RESTORE (Restore all factory presets) Enter Number 22 - Use caution
as this will over-write all presets!
PRE, CHS, DL, REV Parameter List - - continued....