Rocktron Pulse Tremolo - Manual (Page 7)

Speed Control - Adjusts the speed at which the tremolo signal modulates (or
increases or decreases in volume). Turning this control clockwise increases
the speed. Turning it counter-clockwise decreases the speed.
Active LED - When lit the pedal is “active” or “on”
Intensity Control - Adjusts the amount of modulation for the tremolo signal.
Turning it clockwise increases the depth of tremolo. Turning it counter-
clockwise decreases the depth of tremolo. Lower Intensity settings will
produce more subtle tremolo effects, while higher settings will result in a more
extreme tremolo effect.
DC 9V Input - To use external power (not provided) use only a 9-Volt DC
adapter
Waveform Select Switch - This switch determines the “waveshape” of the
tremolo signal. Selecting a different waveform produces a different tremolo
effect.
Input - Using a standard guitar cable with a 1/4” jack, plug your guitar into
this jack.
Output Jack - Using a standard guitar cable with a 1/4” jack, connect to your
next effect or directly into your amplifier.
On/Off Switch - This switch determines whether the pedal is “on” or “off” -
When ON the blue LED will be lit. When OFF the LED will not be lit.
9-Volt Battery Compartment - to access pull on small tab labeled “OPEN”.
Replace with a new 9-Volt battery. Always remember to unplug your guitar
cords from the pedal to conserve battery life. Some battery drain may take
place when unit is plugged in (even if the unit is bypassed).
1
2
3
4
5
6
7
8
9
Controls