Simaudio 600i Integrated Amplifier - Manual (Page 14)

600i Dual-Mono Integrated Amplifier
____________________________________________________________________________________
14
3. To change the RC-5 system codes, rotate the
volume control to scroll through the available
sets of RC-5 compatible codes: “SYS11”,
“SYS14”, “SYS15”, and “SYS19”.
4. Once you’ve decided on one, Press “OK” and
“SAVED” will appear briefly in the display
followed by “IR CODE”.
5. From this point you can (i) exit from the Setup
procedure by pressing the “Setup” button again
and “EXITING” will appear in the display or (iii)
continue with the Setup procedure by disabling
the infrared remote sensor, changing the IR
codes, resetting the 600i back to factory default
status (see the following example), configure
the 12 Volt Trigger Output or configure more
inputs (examples on previous pages).
Reset the MOON 600i software settings back to their factory defaults:
1. You may either continue were we left off in the
previous example by turning the volume control
until “RESET” appears in the display OR enter
into the “Setup” mode from the beginning by
pressing the “Setup” button and then rotating
the volume control until “RESET” appears in the
display.
2. Press “OK” and “RESET N” will appear in the
display.
3. Rotate the volume control until “RESET Y”
appears in the display.
4. Press “OK” and “SURE ? N” will appear in the
display.
5. Rotate the volume control until “SURE ? Y”
appears in the display.
6. Press “OK” and “SAVED” will briefly appear in
the display followed by “RESET”.
7. Press the “Setup” button again and “EXITING”
will appear in the display.