Simaudio 320S Power Supply - Manual (Page 8)

320 S Power Supply
____________________________________________________________________________________
8
310LP Internal Settings
A B A B
Figure 1: MOON 310LP Circuit Board layout
Prior to connecting your MOON 310LP Phono
Preamplifier to the MOON 320S Power Supply,
you must move two (2) internal jumpers inside your
MOON 310LP. Please refer to page 13 of your
MOON 310LP owner’s manual for detailed
instructions on how to remove the chassis cover.
Referring to the above diagram of the 310LP, you
will see an array of four (4) jumper sockets labeled
STR1, STR2, STR3 and STR4. The factory default
position for the 2 jumpers is in sockets STR2 and
STR4 (positions B in figure 1). To properly operate
the MOON 310LP in conjunction with the MOON
320S, you will need to move these 2 jumpers into
sockets STR1 and STR3 (positions A in figure 1).
Failure to make these adjustments may cause
damage that is not covered by warranty.