Singing Machine SML383 - Manual (Page 10)

CD OR CD+G OPERATION
PROGRAM
! Use this button to program and play back songs in a preselected order.
Step 1: Programming should be done in the stop mode only. Press the PROGRAM button until the
PROGRAM LED flashes, the track will read [ ].
Step 2: Press the SKIP buttons ( - SKIP - ) to select a desired track.
Step 3: Press PROGRAM button to confirm entry. You can repeat the same steps up to a maximum of 20
tracks.
Step 4: Press PLAY button when you have completed programming and you are ready to start singing.
! Press the STOP button to clear all the programmed entries.
DISCO LIGHT OPERATION
! To illuminate the Disco light, press the Disco Light ON/OFF button to switch it ON.
! Press it again to switch it off.
KARAOKE FUNCTIONS
Sing a long with the music by plugging in the provided microphone into either one of the microphone jacks
on the unit.
D Warning - Tapping or dropping the microphone while it is on can permanently damage your microphone. Resist
the urge to swing the microphone around by the cord!
MIC VOLUME
Adjust the MIC VOLUME control to a desired level and obtain the best performance.
D Warning - To avoid Microphone feedback please avoid being too close to the speaker.
ECHO
Adjust the ECHO control to enhance your voice for a concert hall effect.
BALANCE
Adjust the BALANCE control between the prerecorded singer’s voice and the music when using a multiplex karaoke disc.
(Please see Glossary of term to learn more about multiplex on our website.)
AUTO VOICE CONTROL
AUTO VOICE CONTROL can be activated by pressing the A.V.C. ON/OFF button. The vocals on the multiplex recording
will be muted when the singer starts to sing through the microphone. When the singer stops to sing, the vocals will resume
to normal.
E9
H
S
I
L
G
N
E
H
S
I
L
G
N
E