Singing Machine SMI440 - Manual (Page 5)

4
Operation
u
1 Press the Power On/Off button to
turn the unit on; the Bluetooth
indicator will blink yellow. After four
seconds, it will slowly blink blue, and
then after six seconds, it will start
blinking rapidly to indicate it is in
Pairing mode.
2 On the Bluetooth device, enable
Bluetooth and select “OUTDOOR
SPEAKER” from the Device List.
(Refer to the user manual of the
device to be connected for detailed
operations.) Press the Bluetooth
Pairing/Play/Pause4;button to
initiate pairing. If the Bluetooth
device prompts for a passcode, use
“0000”. Some Bluetooth devices will
ask you to accept the connection. If
the units are paired properly, the
speaker will beep twice. If it failed, the
Bluetooth indicator will blink slowly.
If the pairing fails, perform the following:
3 Press and hold the Bluetooth Pairing/
Play/Pause4;button until the
Bluetooth indicator blinks quickly to
enter the Pairing mode. On the
Bluetooth device, enable Bluetooth
and select “OUTDOOR SPEAKER” from
the Device List (see step 2 above).
Pairing a Bluetooth Device
w
On some devices such as computers, once paired you must select the unit from the
Bluetooth menu and choose “Use as Audio Device (stereo)” or similar. Pairing remains
intact when the unit and/or your Bluetooth device is taken out of communication range.
An active connection will be re-established when your Bluetooth device returns within
range. When the Bluetooth function of your Bluetooth enabled device is turned on
again, reconnection can be achieved by pressing the
button.
Tip: If you want to connect your
Bluetooth speaker to another Bluetooth
audio device, you need to disconnect
current device first and follow the steps
at right to make a new connection.
SMI440-ENG-SPA v1_Layout 1 7/15/13 12:54 PM Page 5