Sioux Tools TP9A - Manual

1
Printed In U.S.A.
INSTRUCTIONS & PARTS LIST FOR TP9A SERIES TAPPERS
SERIAL “C”
Read and understand "Safety Instructions For Air Tools" and these instructions before
operating this tool.
Form ZCE640B
Date 2004July1/A
Page 1 of 18
AIR SUPPLY
The efficiency of the tool is dependent on the proper supply of clean dry air at 90 psig (6.2 bar). The use of a line filter, pressure
regulator, and lubricator will insure maximum output and life of tools. Before connecting tool, blow out the air line to remove water
and dirt which may have accumulated.
HOSE AND HOSE CONNECTIONS
Supply hose should be not less than 1/4" (6.4 mm) I.D. Extension hoses should be at least 3/8" (10 mm) I.D. Use couplings and
fittings with at least 3/8" (10mm) I.D.
LUBRICATION
Use SIOUX No. 288 air motor oil. An airline lubricator, set to deliver 2 to 4 drops per minute, is recommended. If a lubricator is not
used, add .04 oz. (1.2cc, 12 to 15 drops) of oil into the air inlet twice daily.
Lubricate the gearing every 100 hours of operation with SIOUX No. 289A grease.
GENERAL OPERATION
The direction of spindle rotation is controlled by the reversing button. When the button is depressed, the spindle rotates
counterclockwise. Always depress the button fully to obtain full power. The reversing button can be locked in the
reverse direction by fully depressing and rotating the button clockwise.
TO INSTALL A TAP
• Remove rubber collet and collet nut from the chuck body.
• Loosen back jaws with a hex wrench.
• Insert tap into chuck body so that the tap driving square is in the back jaws.
• Tighten the back jaws onto the tap driving square with a hex wrench.
• Install the rubber collet and collet nut over the body of the tap and tighten with an open end wrench.
TO TAP A HOLE
• Make sure the hole to be threaded is the proper size for the tap.
• Apply a thread cutting lubricant.
• Hold the tap square and in line with the hole.
• Start the tool.
• When the tap reaches the desired depth, press the reverse button on top of the tool to reverse the rotation of the tool.
Certain conditions and materials may cause the tap to stick, causing a sudden movement of the tool.
Be ready for this movement. Have a firm footing at all times. Keep a firm grip on the tool at all times.
Sudden movement of the tool can cause injury.
When the rotation of the tool is reversed, the force on your hand will reverse.
Be ready for this reverse force. Have a firm footing at all times. Keep a firm grip on the tool at all times.
Reversal of force can cause injury.