Sioux Tools RS9AY-210 - Manual

1
Printed In U.S.A.
INSTRUCTIONS & PARTS LIST FOR RS9A-210, RS9AS-210, & RS9AY-210 RIVET SHAVER
SERIAL “B”
Read and understand "Safety Instructions For Air Tools" and these instructions before
operating this tool.
AIR SUPPLY
The efficiency of the tool is dependent on the proper supply of clean dry air at 90 psig (6.2 bar). The use of a line filter, pressure regulator,
and lubricator will insure maximum output and life of tools. Before connecting tool, blow out the air line to remove water and dirt which
may have accumulated.
HOSE AND HOSE CONNECTIONS
Supply hose should be not less than 3/8" (10 mm) I.D. Extension hoses should be at least 1/2" (13 mm) I.D. Use couplings and fittings
with at least 3/8" (10 mm) I.D.
LUBRICATION
Use SIOUX No. 288 air motor oil. An airline lubricator, set to deliver 2 to 4 drops per minute, is recommended. If a lubricator is not used,
add .04 oz. (1.2 cc, 12 to 15 drops) of oil into the air inlet twice daily.
GENERAL OPERATION
Start the tool by depressing the lever or pulling the trigger.
The motor speed on the RS9AS-210 can be adjusted with the screw in the housing (#28).
INSTALLING CUTTERS
• Remove the nose piece (#14).
• Press the lock button (#4) to lock the driver shaft.
• Screw the cutter into the driver shaft (#8).
• Install the nose piece.
Make sure the nose piece inside diameter matches the cutter outside diameter.
• Adjust the depth of cut with the adjusting ring (#11) to cut rivet flush with the surface.
It is best to initially adjust the tool to cut the rivet slightly above the surface and then continue to adjust the tool in increments
until the rivet is cut flush with the surface.
SHAVING OR MILLING RIVETS
• Place the nose piece over the rivet. The stabilizer will aid in maintaining proper alignment with the rivet.
• Start the tool.
• Press down on the tool until the cutter contacts the rivet.
• Continue pressing until the rivet is cut flush with the surface.
If the depth of cut is properly adjusted, the cutting action will stop automatically.
• Shut off the tool and remove from the surface.
Form ZCE648A
Date 2004January28/A
Page 1 of 12
Catalog No. *Sound Pressure dBA *Sound Power dBA *Vibration m/s 2
RS9A-210 79.96 92.56 Less Than 2.5
RS9AS-210 80.28 92.21 Less Than 2.5
RS9AY-210 80.00 93.00 Less Than 2.5
*per PN8NTC1 *per PN8NTC1 *per ISO 8662
SOUND AND VIBRATION READINGS
DECLARATION OF CONFORMITY
We, Sioux Tools Inc., 250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA, declare under our sole responsibility that the products
RS9A-210, RS9AS-210, & RS9AY-210, including 5, 6, 7, 8, 9, 10 Suffixes
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
EN 792 (draft), EN 292 Parts 1&2, ISO 8662, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.
January 1, 2004
Murphy, North Carolina, USA
Date and place of issues
Gerald E. Seebeck
President
Sioux Tools Inc.
Name and position of issuer Signature of issuer