Sioux Tools 1296L - Manual

1
Form ZCE483
Date 2003 June 23/C
Page 1 of 8
Printed In U.S.A.
INSTRUCTIONS FOR SIOUX 1292, 1296, 1292L, 1296L POLISHERS
Read and understand "Safety Instructions For Air Tools" and these instructions before operating this tool.
AIR SUPPLY
The efficiency and life of this tool depend on the proper supply of clean, dry, lubricated air at a maximum of 90 psig (6.2 bars)
max. The use of a line filter, pressure regulator, and lubricator is recommended.
Before connecting the tool to the air line, blow out the line to remove any water or dirt which may have accumulated.
HOSE AND HOSE CONNECTIONS
A 3/8” (10 mm) I.D. air supply hose is recommended. Extension hoses should not be less than 1/2” (13 mm) I.D. 3/8” (10 mm)
I.D. couplings and fitting are recommended.
LUBRICATION
Use Sioux No. 288 air motor oil. An airline lubricator, set to deliver 1 to 2 drops per minute is recommended. If an airline
lubricator is not used, add .08 oz (2.4 cc, 25 to 30 drops) of oil to the air inlet twice daily.
GENERAL OPERATION
Start tool by depressing trigger or lever.
*Sound Pressure *Sound Power *Vibration
Catalog No. dBA dBA m/s 2
1292 80.2 92.6 7.5
1296 80.2 92.6 7.5
1292L 80.2 92.6 7.5
1296L 80.2 92.6 7.5
*per PN8NTC1 *per PN8NTC1 *per ISO 8662-8
SOUND AND VIBRATION READINGS
This polisher is not guarded for use with a grinding wheel.
Do not operate this polisher with a grinding wheel.
Operating this polisher with a grinding wheel can cause injury.
Polishing pads that rotate at excessive speed can burst.
Make sure polishing pad has a higher speed rating than the tool. Do not exceed rated air pressure.
Polishing pads that burst can cause injury.
Tools left connected to the air supply can start unexpectedly.
Always remove the tool from the air supply before changing polishing pads or doing any service on the tool.
Tools that start unexpectedly can cause injury.
WARNING
DECLARATION OF CONFORMITY
We, Sioux Tools Inc., 250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA, declare under our sole responsibility that the products
1292, 1296, 1292L, 1296L
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
EN 792 (draft), EN 292 Parts 1&2, ISO 8662, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.
June 1, 2003
Murphy, North Carolina, USA
Date and place of issues
Gerald E. Seebeck
President
Sioux Tools Inc.
Name and position of issuer Signature of issuer