SkyRC Micro Digital Pitch Gauge - Manual (Page 2)

Digital P
itch G
auge
DPG-020
- 2 -
HOW TO USE
Press “POWER” button to turn on the power. For correct pitch measurements, DPG-020
digital pitch gauge must be zeroed before being used. Press “POWER” button once to zero
the gauge. Please refer to the below instruction to understand how to use DPG-020. After
used, Press “POWER” button for about two seconds to turn off.
HOW TO CHANGE BATTERIES
Low battery could contribute to reduced screen brightness and abnormal startup. Please
replace battery should this occurs.
Open the battery compartment by removing the four screws at the back of the pitch gauge
with a philips-head screw driver.
Remove the battery compartment cover.
Insert / replace one CR2032 batteries while observing the correct polarity.
Close the battery compartment and fasten it with the four screws. 1.
2.
3.
4.
Should the pitch gauge display abnormal behavior after accidental shock or impact, proceed
to remove and re-install battery to reset the device.
Manufactured by
SKYRC TECHNOLOGY CO., LTD.
www.skyrc.com
RoHS
7504-0379-01
Place the DPG-020 horizontally
leveled with top of helicopter
frames.
Press “POWER”
to zero the
gauge.
ZERO THE GAUGE
Mount the DPG-020 on main
blade to measure the pitch.
MEASURE THE PITCH
Digital Pitch Gauge DPG-020
We guarantee this product to be free of manufacturing and assembly defects for a period of one year
from the time of purchase. The warranty only applies to material or operational defects, which are
present at the time of purchase. During that period, we will repair or replace free of service charge for
products deemed defective due to those causes.
For any repair or replace service, please contact your dealer in the first instance, who is responsible for
processing guarantee claims. This warranty is not valid for any damage or subsequent damage arising
as a result of misuse, modification or as a result of failure to observe the procedures outlined in this
manual.
WARRANTY AND SERVICE