SkyRC Digital Pitch Gauge - Manual (Page 2)

- 2 -
HOW TO USE
Press “POWER” button for about two seconds to turn on the power. For correct pitch
measurements, DPG-010 digital pitch gauge must be zeroed before being used. Press
“ZERO” button once to zero the gauge. Please refer to the below instruction to understand
how to use DPG-010. After used, Press “POWER” button for about two seconds to turn off.
HOW TO CHANGE BATTERIES
Low battery could contribute to reduced screen brightness and abnormal startup. Please
replace battery should this occurs.
Open the battery compartment by removing the four screws at the back of the pitch gauge
with a philips-head screw driver.
Remove the battery compartment cover.
Insert / replace two CR2032 batteries while observing the correct polarity.
Close the battery compartment and fasten it with the four screws. 1.
2.
3.
4.
Should the pitch gauge display abnormal behavior after accidental shock or impact, proceed
to remove and re-install battery to reset the device.
Manufactured by
SKYRC TECHNOLOGY CO., LTD.
www.skyrc.com
RoHS
7504-0315-01
Place the DPG-010 horizontally
leveled with top of helicopter
frames.
Press “ZERO”
to zero the
gauge.
ZERO THE GAUGE
Mount the DPG-010 on main
blade to measure the pitch.
MEASURE THE PITCH