Installation – Sonodyne AMC+120 User Manual
Page 7
100V Line
70V Line
4 ohm voice-coil
OUTPUT
DISTANCE
WIRE SIZE
AMC
+
30
AMC
+
60
AMC
+
120
AMC
+
250
100V
Up to 50m
AWG26(0.12mm
2
)
AWG26(0.12mm
2
)
AWG24(0.2mm
2
) AWG22(0.35mm
2
)
50m–200m
AWG24(0.2mm
2
)
AWG20(0.5mm
2
)
AWG18(0.75mm
2
) AWG16(1.5mm
2
)
Over 200m
AWG20(0.5mm
2
)
AWG18(0.75mm
2
)
AWG16(1.5mm
2
) AWG13(2.5mm
2
)
70V
Up to 50m
AWG26(0.12mm
2
)
AWG24(0.2mm
2
)
AWG22(0.35mm
2
) AWG18(0.75mm
2
)
50m–200m
AWG20(0.5mm
2
)
AWG18(0.75mm
2
)
AWG16(1.5mm
2
) AWG13(2.5mm
2
)
Over 200m
AWG18(0.75mm
2
)
AWG16(1.5mm
2
)
AWG13(2.5mm
2
) AWG10(6.0mm
2
)
4 ohm
Up to 10m
AWG18(0.75mm
2
)
AWG18(0.75mm
2
)
AWG18(0.75mm
2
) AWG18(0.75mm
2
)
10m–30m
AWG13(2.5mm
2
)
AWG13(2.5mm
2
)
AWG13(2.5mm
2
) AWG13(0.35mm
2
)
Over 30m
Not Recommended
Not Recommended
Not Recommended
Not Recommended
NOTE: Only connect one output – either Distributed Line or Low Impedance.
Line Output
The LINE output XLR can be used to connect up to 6 booster amplifiers. Balanced wiring
(shielded pair cable) is recommended.
NOTE: When wiring the LINE output as unbalanced, Pin2 should be wired as hot and Pin1
should be wired as ground/shield. Do not wire Pin3.
REC Output
The REC output wiring
should be kept as short
as possible.
Input Connections
For wiring balanced in, pin 2 is hot.
Unbalanced wiring on the microphone
inputs is not recommended.
Balanced input wiring (shielded pair cable)
is recommended. Unbalanced RCA wiring
should be keep as short as possible.
Direct Output
The output terminal strip accepts wire sizes from 16-22AWG
(1.5mm2 – 0.35mm2) or spade lugs. The following table should be used as a
guideline for cable sizes. Regulations in your area may require different gauged
wire and should be checked before using.
PAGE 7
AMC
+
SERIES INSTALLATION AND OPERATION MANUAL
INSTALLATION