Speck Electronics X.Sum - Manual (Page 22)

Chapter 3 Operation Section 18
18
19
20
21
This AC (mains) power inlet accepts a standard IEC power cord. Before
connecting the power cord, make certain that power cord matches the
operating voltage shown on the voltage setting switch [21].
The ground pin of the power cord is internally connected to the chassis. For
safety reasons, do not lift the ground on the power plug by using a ground
lift adapter.
The AC power inlet has integral fuse holder that uses a 5mm x 20mm slow
blow type fuse. To avoid the risk of fire, always replace the fuse with the
correct value fuse as marked on the rear panel; .2 amp for the 120V model, or
.1 amp for the 230V model.
This ON/OFF power switch applies AC (mains) power to the PS-6 power
supply and the X.Sum mixer.
The PS-6 power supply will operate at mains voltages between 100-120 and
220-240. This two position switch must be set to the correct voltage.
Set the voltage selector switch to the "115" position if your mains voltage is
100VAC or 120VAC. Set the voltage selector switch to the "230" position if
your mains voltage is 220VAC, 230VAC or 240VAC.
Always turn "Off" the power before changing the 115/230 voltage selector.
18. A.C. Power Inlet
19 . Fuse
20. Power Switch
21. Voltage Selector
Switch