Speck Electronics MicPre 5.0 - Manual (Page 8)

The MP5.0 is supplied with the following list of accessories:
Operations Manual
Power cord (NA version only)
(4) rubber bumpers - used for table top mounting or
stacking multiple units.
(2) 6-32 x ½” machine screws - supplied to mount the
MP 5.0 to an optional rack shelf.
The following is a list of optional accessories that are available
from the factory or your Speck dealer:
Mix link interface cables - to interface additional
MP 5.0’s.
2 unit cable - P/N MP50-Link2
4 unit cable - P/N MP50-Link4
6 unit cable - P/N MP50-Link6
8 unit cable - P/N MP50-Link8
M-S interface cable - a 12” cable used to connect two
MP5.0’s for use in a M-S micing configuration.
P/N MP50-MS
D.C. interface cable - Used to supply power to the
Model ASC equalizer.
P/N ASC-DCI
1U rack tray - may be used to rack mount two
MP 5.0’s or one MP 5.0 and one Model ASC equalizer.
The MP 5.0 is intended to operate from an AC power source that
does not apply more than 120 Volts RMS (Model MP5.0-NA) or
240 Volts RMS (Model MP5.0-EU) between the supply
conductors. Always make certain that power cord matches the
operating voltage shown on the rear panel above the power switch.
To avoid electrical shock, plug the power cord into a properly
wired receptacle. The ground pin of the power cord is internally
connected to the chassis. For safety reasons, do not lift the
ground on the power plug by using a ground lift adapter.
The MicPre 5.0 should never be exposed to rain or moisture.
Standard accessories
Optional accessories
Power Source
Grounding the product
Chapter 1 Introduction Section 2
Operator Saftey
Summary