SpectraCal Fujifilm IS-Mini User Manual
Fujifilm is-mini calman setup guide
3528 Bagley Ave. N. Seattle, WA 98103 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 |
Fujifilm IS-mini
CalMAN Setup Guide
CalMAN takes advantage of the features of the Fujifilm IS-mini Image Processing System to calibrate a
video display with a 10-bit 26x26x26 3D cube lookup table (LUT) for use with SMPTE legal levels or with
full range video level signals. The IS-mini functions as a calibration target generator for video display LUT
calibration. This setup guide assists you in calibrating a video display with the IS-mini and the CalMAN
Color Cube workflow.
Recommended CalMAN Workflow:
Color Cube (3D LUT)
Required IS-mini Firmware:
All versions are acceptable
IS-mini Control Connection:
USB A to USB mini cable (supplied)
USB driver contained in SpectraCal Device Driver Kit
IS-mini Control Setup:
To set up an IS-mini for 3D LUT display calibration:
1. Install the IS-mini USB driver by running the SpectraCal Device Driver Kit, available for
download on the SpectraCal website.
2. Connect a USB cable between the IS-mini and your calibration computer.
3. Connect the IS-mini SDI or HDMI signal output to the video display to be calibrated (no input
signal is required to the IS-mini during display calibration).
4. Power on the IS-mini.
IS-mini Output Format:
The IS-mini output signal format is simply a pass-thru version of the input signal format, so there is no
setting provided or required. With no input signal, the IS-mini output defaults to 720p60. During display
calibration, the internal IS-mini pattern generator provides the output signal.
CalMAN 3D LUT Display Calibration
CalMAN can calibrate the 3D LUT in the IS-mini with a direct USB control connection. To produce an
optimized 3D LUT calibration file and automatically load it into the IS-mini:
1. In CalMAN, load the "Color Cube (3D LUT)" workflow.
2. Proceed through each step of the workflow in the normal fashion, using the following notes
for guidance on the indicated workflow pages.
3. On the CalMAN Session Setup page, click the Find 3D LUT Device button, then select "Fujifilm
– IS-mini (USB).”