SpectraCal Panasonic 2013 WT600 - Manual

Panasonic
VT60/ZT60/WT60/DT60, WT600 (US/Canada)
VT60/ZT60/GT60/WT60/DT60/FT60, VT65, WT600 (EU)
VT60/WT60/DT60 (NZ/Asia)
CalMAN Setup Guide
CalMAN automatically calibrates the display’s two point grayscale controls, the 10 point grayscale
controls, and CMS color gamut controls for all the Panasonic models listed above.
Also, the display’s two custom picture modes, Professional 1 (ISF Day) and Professional 2 (ISF Night), can
each be calibrated with individual picture menu adjustments, grayscale adjustments, and CMS
adjustments.
Recommended CalMAN Workflows:

HT Advanced, SI Advanced, or ISF Calibration workflow to optimize Picture controls and calibrate
two point and 10 point grayscale RGB balance controls and CMS color gamut controls.
Recommended Test Patterns:
Plasma displays exhibit power supply luminance limiting with high brightness, high APL test
patterns. This can cause incorrect luminance measurements. To avoid this situation with plasma
displays, use test patterns with the smallest useable window size available from your test pattern
source. Under Window Size, on the CalMAN Source Settings panel, select the smallest window size
that provides a large enough target for your color meter.
Required Panasonic Firmware:

All firmware versions supported
Panasonic Control Connection:

Wireless (Wi-Fi) connection
Note: The Panasonic models listed above support only wireless calibration control, not through
the display’s Ethernet connector.
Panasonic Setup Process:
To enable the display’s ISFccc Viewing Mode:
1. In the Panasonic Setup menu, select Professional Mode (isfccc).
2. Select On.
To connect the calibration computer to a display listed above, through a wireless (Wi-Fi) network:
1. In the Panasonic Network menu, select Network Status.