Spectrum Controls 1769sc-IT6I - Manual (Page 21)

User’s Manual Pub. 0300244-01 Rev. A
Chapter 3
Installation and Wiring
This chapter tells you how to:
•
Determine the power requirements for the modules
•
Avoid electrostatic damage
•
Install the module
•
Wire the module’s terminal block
•
Wire input devices
Section 3.1
Compliance to
European Union
Directives
This product is approved for installation within the European Union and EEA regions. It
has been designed and tested to meet the following directives.
3.1.1 EMC Directive
The 1769sc-IT6I module is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards, in whole or in part,
documented in a technical construction file:
•
EN 50081-2EMC – Generic Emission Standard, Part 2 - Industrial Environment
•
EN 50082-2EMC – Generic Immunity Standard, Part 2 - Industrial Environment
This product is intended for use in an industrial environment.
3.1.2 Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low Voltage, by applying
the safety requirements of EN 61131-2 Programmable Controllers, Part 2 – Equipment
Requirements and Tests.
For specific information required by EN61131-2, see the appropriate sections in this
publication, as well as the following Allen-Bradley publications:
•
Industrial Automation, Wiring and Grounding Guidelines for Noise Immunity,
publication 1770-4.1
•
Automation Systems Catalog, publication B113