Star Headlight & Lantern BKDLXT - Manual

BKDLXT
Constellation Thinline Auxiliary LED Lights
PLIT520 REV. - 8/27/14
BKLD418
Important : This product is used to warn traffic. Improper use may result in
vehicular collision, personal injury and/or death. Star Headlight & Lantern Co.,
Inc., and its subsidiaries shall not be held responsible for damages directly or
indirectly caused by improper use of this product.
• The installer must have a firm knowledge of basic electricity, vehicle electrical systems,
and emergency equipment.
• If you need to drill any holes when installing this light, please take care to check that
BOTH SIDES of your drilling surface are clear from obstructions, to ensure that you do
not damage your vehicle and or pre-existing wiring.
• Choose a mounting location away from any air bag deployment areas.
• Controls should be placed within convenient reach of the driver.
• Use only soap and water when cleaning this product. Use of other chemicals may
discolor the lens and/or housing, thus diminishing the output of the light. Lenses that
have become discolored should be replaced immediately!
• DO NOT use a pressure washer to clean this light. Use of a pressure washer may
damage the light and WILL VOID THE WARRANTY.
Installation Notes
Wiring Notes
When wiring your lights, it is recommended that you take the following
precautions to reduce any Electromagnetic Interference (EMI).
• Keep LED modules and any radios as far away from each other as possible.
• Separate the radio wires and the LED wires.
• The Ground, Power, and Synchronization wires should be bound tightly together as
they run from light to light, through your switchbox, and finally to the battery.
The BKDLXT series heads utilize special connectors designed for use
with the BKLD418-2 controller (sold separately).