Star Headlight & Lantern ULB14 StarBurst Half Phantom Undercover - Manual

PLIT514 REV. - 3/17/14
We have designed a number of
brackets that fit specific
vehicles. This instruction sheet
applies to those that mount to
the rear of your Half or Split
Phantom.
Half and Split Phantom Mounting
Back Mounted Vehicle-Specific Brackets
3. Loosen (LOOSEN, DO NOT REMOVE!!)
the three visor pivot arm screws on one
side of the vehicle with appropriate
screwdriver. (Passenger’s side shown)
1. Remove the two pairs of screws from each light
half and install the enclosed stud brackets at
each location using the same screws you
removed. The tabs on each stud bracket should
point AWAY from the cable joining the two
halves, as shown to the right.
DRIVER
SIDE
PASSENGER
SIDE
4. Slide the forked end of the visor
bracket under the visor pivot
arm that you just loosened.
(Passenger’s side shown)
5. Align the square hole on the other end of
the visor bracket with the visor clip hole.
(Passenger’s side shown)
2. If mounting the Split Phantom, remove
both the driver and passenger visor
clips from the vehicle. Only the
passenger side is necessary for the
Half Phantom.