StorCase Technology S20A133 - Manual (Page 20)

S20A133 User's Guide - Rev. A02 StorCase Technology, Inc.
Installation 13
Figure 9: Unit ID Select Switch Location
3. Use the alignment tool supplied with the DE300 to select the ID number of the
disk drive. Refer to Figure 9 for the location of the Unit ID Select Switch inside
the receiving frame.
WARNING: Selecting an invalid ID number, or selecting the same unit ID
number on different devices may cause unpredictable results
and the computer system may not recognize the installed de-
vice(s). If the computer system can not recognize the boot disk,
the computer may fail to start-up properly.
4. After selecting an appropriate unit ID number, replace the DE300 carrier in the
receiving frame, and LOCK IT INTO PLACE.
5. The new drive(s) may need to be formatted or initialized prior to use with the
operating system and applications software. Refer to the drive and/or
computer manufacturer's documentation for formatting information.
Alignment Tool
Unit ID Select
Switch (3 plcs)
0515b