StorCase Technology DS351 - Manual (Page 14)

6 Installation
StorCase Technology, Inc. DS351 User's Guide - Rev. B02
INSTALLATION
Installing the Drive(s) into the DS351
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive(s) being installed. Also refer to the manufacturer's documentation provided with
the drive(s). A #2 Phillips and a flat blade screwdriver will be required.
Removing the Access Panel
WARNING: Remove ALL power from the DS351 before removing the access panel. The
DS351 contains NO USER SERVICEABLE PARTS inside the unit.
1. Unplug the DS351 and verify that ALL cables have been disconnected.
2. Place the DS351 on a soft clean surface to protect the finish of the chassis.
3. Remove the eight (8) screws located on the top of the unit (Figure 5).
4. Remove access panel by carefully lifting the front of the panel and sliding (forward)
off the chassis (Figure 5).
5. To reinstall panel, simply reverse the above mentioned steps.
Figure 5: Access Panel