Inserting a drive carrier (with drive installed), Removing a drive carrier (with drive installed), Configuring device and chassis settings – StorCase Technology 12-Bay 4U Fibre/SATA JBOD User Manual
Page 19
10
User Interface
StorCase Technology, Inc.
InfoStation 12-Bay JBOD User's Guide - Rev. A00
Inserting a Drive Carrier (with Drive Installed)
NOTES:
A new drive can be inserted into an empty bay at anytime. However, the drive
will not be ready for access until the following procedure is followed.
The key lock is only to prevent unauthorized removal or installation of the drive
carrier. Locking the key lock is not required for drive carrier operation.
1. Simply insert the drive carrier into the empty bay.
2. Drive is ready to be accessed when the Drive Ready LED glows BLUE.
Removing a Drive Carrier (with Drive Installed)
CAUTION:
Proper procedure must be followed when removing a disk drive from the drive
bay. It is the responsibility of the operator to ensure that the host does not
access the drive while attempting to remove the disk drive, and to follow the
procedure outlined below. Failure to do so may result in loss of data and/or
damage to the drive itself!
NOTE:
Refer to the InfoStation Installation Guide for detailed information on inserting/
removing drives from the InfoStation chassis.
1. Verify that the Drive Activity LED is OFF before removing drive.
2. Unlock the key lock (if locked) and remove the drive carrier by pulling on carrier handle.
Configuring Device and Chassis Settings
NOTE:
Refer to the InfoMon User's Guide for further information.
If necessary, use InfoMon to change any factory default device or chassis settings. Please
refer to the InfoMon User's Guide for further information.