StorCase Technology InfoStation 5-Bay SATA 3Gbps RAID - Manual (Page 22)

12 Installation
StorCase Technology, Inc. InfoStation 5-Bay RAID User's Guide - Rev. C00
Removing/Installing the Power Supply Module
WARNING: Handling certain plastic coated cords or cables associated with this product
may expose you to lead, a chemical known to cause birth defects or other re-
productive harm. Wash your hands after handling cable(s).
CAUTION: The power supply module contains NO USER SERVICEABLE PARTS inside the
unit. Warranty is VOID if module is opened. Refer ALL servicing to qualified
service personnel!
1. Turn OFF power to the power supply module via the power switch located on the
chassis.
2. Remove the crossbar securing the power supply and fan modules to the InfoStation
chassis.
3. Remove the power supply module by grasping handle and pulling out from chassis.
4. To reinstall power supply module, simply insert until module "clicks" into place.
5. Reinstall the crossbar.
Removing/Installing the Fan
CAUTION: The fan contains NO USER SERVICEABLE PARTS inside the unit. Warranty is
VOID if module is opened. Refer ALL servicing to qualified service person-
nel!
NOTES: The fan is hot-swappable. The chassis may remain on when removing and
installing the fan.
A #2 Phillips screwdriver will be required for this procedure.
1. Loosen and remove the four (2) #6-32 Phillips screws securing the fan to the
InfoStation chassis.
2. Carefully remove fan from chassis and disconnect fan cable from the InfoStation
motherboard.
3. To reinstall fan, simply reverse above mentioned steps.