StorCase Technology SNMP Module - Manual (Page 13)

6 SNMP Configurations
StorCase Technology, Inc. InfoStation SNMP Module User's Guide - Rev. A00
Set-Up
NOTES: Default Static IP address = 192.168.1.24
Default Submask address = 255.255.255.0
InfoMon must be at least Rev. 3.1 or higher to change the SNMP Module IP
address. The latest InfoStation UI firmware can be downloaded from the
StorCase web site.
Refer to the InfoMon User's Guide for further information.
StorCase recommends the use of Static IP addresses when configuring the SNMP Module. A
default Static IP address has already be assigned to the module. If necessary, the user may
change the default address via InfoMon (Rev. 3.1 or higher). The InfoStation SNMP Module
must be configured using the InfoMon Monitoring Utility software as shown in Figure 4 below.
Refer to the InfoMon User's Guide for further information.
Figure 4: InfoMon SNMP Set-Up