Summit Audio TD-100 Instrument Preamplifier and D.I. - Manual (Page 6)

Basic Operation
6 Summit Audio, Inc.
Basic Operation
Important: For proper
operation of the
TD-100 (or any vacuum
tube device for that
matter), allow the unit to
warm up with power on
for 15 minutes before
use.
Important: Do not block
the cooling holes and
allow adequate
ventilation.
Just Plug-in & Go
1. Plug your instrument into the front panel input jack.
2. Connect either the rear panel balanced Mic or Line output to
the input of your mixer or recorder.
(An unbalanced cable can
be used with the Line Level output.)
3. Adjust the Output Gain for an optimal signal level.
4. Adjust the front panel Impedance control to match for the
best sound.
5. Start playing!