SurgeX SA-82 - Manual

SA-82-AR / XF2-AR Quick Start Guide Page 1
Connections
1. Connect Network. The SA-82-AR/XF2-AR supports 10/100
Ethernet using the cable supplied, or other suitable
unshielded twisted pair (Cat 5) cabling.
2. Connect Powered Equipment. Connect the device to be
powered On and Off to the duplex receptacle located on the
rear panel. If the connected equipment has a Power switch,
leave it in the On position to allow the SA-82-AR/XF2-AR to
control the power.
IMPORTANT: Ensure that the total combined load of all
controlled devices does not exceed 8 Amps.
3. Connect Power Mains. Connect one end of the supplied
power cord to the IEC connector labeled “AC Input”, and the
other end to a properly grounded AC outlet.
Web Browser Access
Factory Default IP Address: 192.168.1.254
Factory Default Security Credentials:
Role
Username Password
Administrator admin admin
User user user
To access the SA-82-AR/XF2-AR from the default IP Address,
the PC must be on the same local network (IP address of
192.168.1.nnn). If it is not, change the IP address using one of the methods on the following
page.
After pointing a web browser to the IP address of the SA-82-AR/XF2-AR, enter the
Administrator Username and Password to access the complete Setup features. Entering the
User credentials will enable access to only the power control. Once the user is validated, the
Control and Status page is displayed.
Click on the appropriate button to control the power. During power cycling, the Power Status bar
will indicate the temporary status, and will have a blue background. Once the cycle is complete,
the status bar will revert to its original condition.