SurgeX EV-23010 - Manual (Page 4)

Software User Manual
4. Install Data Interface Cable
a. Automatic Installation (Requires Internet connection)
i. Plug the USB side of the Data Interface Cable into an available USB port.
ii. Windows will automatically detect and install appropriate device driver
files for the Data Interface Cable.
• If a “Found New Hardware” pop-up box appears, follow the on-
screen instructions and allow Windows to search online for driver
files.
• The installation could take several minutes to search for and
download appropriate driver files. Once the files are found, follow
the on-screen instructions to install.
• Note: The driver installation process will first install USB Serial
Converter driver files, and then will install USB Serial Port drivers
separately.
b. Manual Installation
In the event that the automatic driver installation process was not successful, or if
no internet connection is available, the Data Interface
Cable driver files may be
installed manually.
• Select “Install Drivers” during the Software Installation process.
• Or run “enVision PCS Interface Setup” from:
Start/All Programs/ESP SurgeX/ESP enVision PCS
c. Once the Data Interface Cable has been successfully installed, it will appear
in Device Manager as “USB Serial Port (COMx)” under “Ports (COM & LPT)”.
II. Using the Software
1. Physical Connections
a. Plug the USB side of the Data Interface Cable into an available USB port.
b. Plug the RJ-11 side of the Data Interface Cable into the RJ-11 “OUT” jack
labeled “Data Port” on the enVision enabled unit, which is the jack closest to the
LCD.
c. Note: The enVision PCS must be powered by AC Mains for communications with
the software to operate.
2. Start the Software
a. Double-click the desktop shortcut labeled “enVison”, or use the
“ESP SurgeX enVision PCS” Start Menu shortcut located at:
Start/All Programs/ESP SurgeX/enVision PCS
© 2014 Electronic Systems Protection, Inc. / Technical Support: 1-800-645-9721 / espei.com
3