Tenqa HP-109 - Manual (Page 8)

6
warning
Failure to follow these safety instructions could result in fire, electric shock, or
other injury or damage.
handling the hP-109
Do not drop, disassemble, open, crush, bend, deform, puncture, shred, microwave,
incinerate, paint, or insert foreign objects into the HP-109. Use common sense
when operating this and all electronic devices.
aVoid water and wet locations
Do not use the HP-109 in the rain, or near sinks, bathtubs or other wet locations.
Take care not to spill any food or liquid on the HP-109. In case the HP-109 gets
wet, unplug all cables, turn off the HP-109 before cleaning, and allow it to dry
thoroughly before turning it on again. Do not attempt to dry the HP-109 with an
external heat source such as a microwave oven or hair dryer.
rePairing the hP-109
Never attempt to repair or modify the HP-109 yourself. The HP-109 does not
contain any user-serviceable parts. If the HP-109 has been submerged in water,
punctured, or subjected to a severe fall, do not use it until you take it to a Tenqa
Authorized Service Provider.
The rechargeable battery in the HP-109 should be replaced only by a Tenqa
Authorized Service Provider.
charging the hP-109
To charge the HP-109, only use the included Tenqa USB charging cable with a USB
port on another device that is compliant with the USB 2.0 standard. If using a USB
wall adapter, use a compatible device and be aware the Tenqa is not responsible
for any damage resulting from using such devices.
Read all safety instructions for any products and accessories before using with
the HP-109. Tenqa is not responsible for the operation of third party accessories or
their compliance with safety and regulatory standards.
If you use the Tenqa USB charging cable to charge the HP-109, make sure that the
cable is fully assembled and in good condition before you plug it into a USB port.
Do not connect or disconnect the Tenqa USB Power Adapter with wet hands. Do
not use any other USB charging cable other than the Tenqa provided USB charging
cable to charge the HP-109. Unplug the Tenqa USB Power Adapter if any of the
following conditions exist:
The USB cable or plug has become frayed or damaged. •
The USB cable is exposed to rain, liquid, or excessive moisture. •
You suspect the adapter needs service or repair. •