Thermionic Culture THE EARLYBIRD 2.2 2 Channel mic, pre amp with eq - Manual (Page 9)

©Thermionic Culture Ltd., September 2010 8
4 Connections
There is a row of input and output sockets on the back of the
Earlybird, which allow it to be left permanently connected for
it’s various configurations.
4.1 Mic
input
These XLR sockets are for connecting microphones to
the Earlybird. The 48-volt phantom power supply will
applied to these sockets only. The Mic settings on the
Function switch will all select these inputs.
4.2 Line input
These XLR sockets are to be used when connecting a
line level signal to the Earlybird. The Line setting on
the Function switch will select these inputs.
4.3 Pullet
These XLR sockets should be used when connecting
the Pullet to the Earlybird. The leads between the
Pullet and these sockets should be as short as
possible in order to avoid picking up any extraneous
noise due to the low signal levels at this point.
Thermionic Culture can supply leads of the correct
length if required.
4.4 Output
These XLR plugs are the signal output points for the
Earlybird.